Effects of Radial Inertia and End Friction in Specimen Geometry in Split Hopkinson Pressure Bar Tests : A Computational Study

Iwamoto Takeshi

Yokoyama Takashi

Mechanics of Materials

The split Hopkinson pressure bar (SHPB) technique has been used widely for the impact testing of materials in the strain-rate range from 10(2) to 10(4) s(-1). However, some specific problems still remain mainly concerning the effects of radial inertia and end friction in a cylindrical specimen on the accurate determination of dynamic stress-strain curves of materials. In this study, the basic principle of the SHPB technique is revisited based on energy conservation and some modifications are made considering radial momentum conservation. It is pointed out that the radial inertia and end friction effects are coupled to each other in the SHPB specimen. Computational simulations using the commercial finite element (FE) code ABAQUS/Explicit ver. 6.8 are conducted to check the validity of the modifications for ductile pure aluminum specimens. Both rate-independent and rate-dependent models are adopted for the test material. Simulations are performed by varying two different control parameters: a friction coefficient between the specimen and the pressure bars and a slenderness ratio of the specimen (or thickness to diameter ratio).

Finite elements

Impact compression

Elastoplasticity

Viscoplastic response

Split Hopkinson pressure bar

Radial inertia

End friction

機械工学 [ 530 ]

英語

Elsevier B.V.

(c) 2012 Elsevier B.V. All rights reserved.

[ISSN] 0167-6636

[DOI] 10.1016/j.mechmat.2012.04.007

[NCID] AA1063514X

[DOI] http://dx.doi.org/10.1016/j.mechmat.2012.04.007