Identification of Rotary Axis Location Errors under Spindle Rotation by using a Laser Barrier Tool Measurement System: Experimental Comparison with R-Test

Ibaraki Soichi

Yanai Eita

システム制御情報学会論文誌

Transactions of the Institute of Systems, Control and Information Engineers

Position and orientation errors of rotary axis average lines are often dominant error sources in the five-axis machining. Many schemes have been studied, and some are now commercially available, such that they can be identified on-machine, and then numerically compensated, by a machine tool user. Many conventional schemes install a measuring instrument or a measured target in a machine spindle, and thus cannot be performed when the spindle is rotating. Rotary axis location errors are often influenced by the machine’s thermal deformation. When the spindle is not rotating, they can be different from actual machining operations. This paper presents the application of a non-contact laser barrier tool measurement system to the identification of rotary axis location errors, when the spindle rotates in the same speed as in actual machining applications. An experimental thermal test is presented to observe the change in rotary axis location errors under continuous machine warm-up by spindle rotation and reciprocal linear axis motions. Experimental comparison with the R-Test, a typical conventional scheme that can be performed only when the spindle does not rotate, shows that rotary axis location errors change quickly after the machine warm-up is terminated.

machine tool

metrology

thermal deformation

error calibration

five-axis

tool measurement

英語

システム制御情報学会

© 2021 The Institute of Systems, Control and Information Engineers

[ISSN] 1342-5668

[ISSN] 2185-811X

[NCID] AN1013280X

[DOI] 10.5687/iscie.34.81

[DOI] https://doi.org/10.5687/iscie.34.81