A machining test to identify rotary axis geometric errors on a five-axis machine tool with a swiveling rotary table for turning operations

Ibaraki Soichi

Yoshida Ibuki

Asano Tetsushi

Precision Engineering

Lately, a cylindrical workpiece of relatively large diameter is often machined by turning operations by a swiveling rotary table in a five-axis machining center. This paper presents a machining test containing features finished by a turning operation by a swiveling rotary table. Unlike conventional machining tests for turning operations described in ISO 13041-6:2009, the present machining test can identify a complete set of position and orientation errors of the axis average line of rotary axes from the geometry of the finished test piece. The radial and axial error motions of the rotary table can be also observed when the swiveling axis is positioned horizontal (A = 0°) and vertical (A = -90°). Experimental demonstration is presented. The rotary axis geometric errors identified from the finished test piece's geometry are compared with those estimated by a conventional error calibration test using a touch-triggered probe and a precision sphere. The uncertainty analysis for the present machining test is also presented.

Five-axis machine tool

Machining test

Turning

Error calibration

Geometric error

英語

Elsevier

© 2019. This manuscript version is made available under the CC-BY-NC-ND 4.0 license http://creativecommons.org/licenses/by-nc-nd/4.0/

This is not the published version. Please cite only the published version. この論文は出版社版でありません。引用の際には出版社版をご確認、ご利用ください。

[ISSN] 0141-6359

[DOI] 10.1016/j.precisioneng.2018.08.003

[DOI] https://doi.org/10.1016/j.precisioneng.2018.08.003