Melting and Solidification of TiNi Alloys by Cold Crucible Levitation Method, and Evaluation of their Characteristics

Matsugi Kazuhiro

Mamiya Hiroshi

Choi Yong-Bum

Sasaki Gen

Yanagisawa Osamu

Kuramoto Hideaki

International Journal of Cast Metals Research

The addition of Re, Fe and Cr into Ti-50mol%Ni has been carried out to improve the oxidation and mechanical properties. The mono phase consisting of TiNi with the B2 type structure was identified in micro-alloyed materials proposed on the basis of the d-electrons concept. Experimentally TiNi alloys were melted and solidified by the cold crucible levitation method (CCLM). The TiNi-(Cr, Fe, Re) alloys with high purity and without contamination from a crucible were prepared, and the homogeneous microstructure was achieved by the diffusion mixing effect of CCLM even in the as-cast alloys which contained Re and Cr with higher melting temperatures and different specific gravities. All alloys were caused the transformation from austenite to martensite phases below or above room temperature. The some alloys had the ability of shape memory even at room temperature. Ternary alloys showed higher flow stress level compared with the binary TiNi alloy. On the other hand, the oxidation at 1273K was promoted by the formation of titanium oxides (TiO2) on the alloy surfaces. The oxidation resistance was improved by the formation of the continuously Cr2O3 film in TiNi-Cr alloys. The alloying effects by ternary elements (Re, Fe, Cr) in the intermetallic TiNi as well as metallic materials were explained well using two parameters used in the d-electrons concept.

shape memory alloys

levitation melting

electron theory

oxidation resistance

ternary TiNi

alloy design

high purity

environmentally friendly materials

金属工学・鉱山工学 [ 560 ]

英語

Maney Publishing

[ISSN] 1364-0461

[DOI] 10.1179/136404608X361873

[NCID] AA11097848

[DOI] http://dx.doi.org/10.1179/136404608X361873