Effect of apex cone shape on fine particle classification of gas-cyclone
Powder Technology 204 巻 1 号
54-62 頁
2010-12-10 発行
アクセス数 : 686 件
ダウンロード数 : 800 件
今月のアクセス数 : 2 件
今月のダウンロード数 : 1 件
この文献の参照には次のURLをご利用ください : https://ir.lib.hiroshima-u.ac.jp/00030815
| ファイル情報(添付) | |
| タイトル ( eng ) |
Effect of apex cone shape on fine particle classification of gas-cyclone
|
| 作成者 |
Nishimura Yusuke
|
| 収録物名 |
Powder Technology
|
| 巻 | 204 |
| 号 | 1 |
| 開始ページ | 54 |
| 終了ページ | 62 |
| 抄録 |
The purpose of this paper is to study the effects of apex cone shape on particle separation performance of gas-cyclones by experiment and CFD studies. It is found that the optimum apex cone angle is 70 degrees. The minimum 50% cut size was obtained by use of this special apex cone. From the flow visualization method by use of soap foam, the upward flow and downward flow coexisted on the surface of this special apex cone. The clear interface between upward flow and downward flow was detected on the apex cone angle of 70 degrees. The effect of the apex cone angle on particle separation performance decreases under high inlet velocity conditions, because most particles are moving in the area away from the apex cone.
The particle separation performance and flow visualization results qualitatively supported the 3-dimensional CFD simulation based on the direct method. |
| 著者キーワード |
Gas-cyclone
Particle separation
Cut size
Particle size
Sub-micron particles
|
| NDC分類 |
化学 [ 430 ]
|
| 言語 |
英語
|
| 資源タイプ | 学術雑誌論文 |
| 出版者 |
Elsevier Science SA
|
| 発行日 | 2010-12-10 |
| 権利情報 |
Copyright (c) 2010 Elsevier B.V.
|
| 出版タイプ | Author’s Original（十分な品質であるとして、著者から正式な査読に提出される版） |
| アクセス権 | オープンアクセス |
| 収録物識別子 |
[ISSN] 0032-5910
[DOI] 10.1016/j.powtec.2010.07.006
[NCID] AA00778424
[DOI] http://dx.doi.org/10.1016/j.powtec.2010.07.006
|
