Optimized design of heaters for flying height adjustment to preserve performance and reliability

Miyake Koji

Shiramatsu Toshiya

Kurita Masayuki

Tanaka Hideaki

Suk Mike

Saegusa Shozo

IEEE Transactions on Magnetics

We developed a thermal flying-height control (TFC) slider to control the flying height of magnetic recording heads. The slider basically consists of a small heater fabricated near the read/write element. This study discusses the effect of heater size and heater location on the change in the flying height at the read/write element. We also discuss the resulting temperature rise due to the additional heat applied by the heater. Specifically, we have found that small heaters generally resulted in lower heater power per unit change in the flying height and lower head temperature rise per unit change in the flying height. In terms of heater location, we have found that a heater closer to the air-bearing surface (ABS) also tends to result in a larger change in the flying height because of the larger protrusion shape. However, the head temperature rose significantly. Therefore, shorter ABS/heater distance was a trade off lower power against higher rise in head temperature. We concluded that smaller heaters and the shorter ABS/heater distance are better as long as head reliability is ensured.

Flying height

Magnetic head slider

Microactuator

Thermal protrusion

電気工学 [ 540 ]

英語

IEEE

Copyright (c) 2007 IEEE. Personal use of this material is permitted. However, permission to reprint/republish this material for advertising or promotional purposes or for creating new collective works for resale or redistribution to servers or lists, or to reuse any copyrighted componet of this word in other works must be obtained from the IEEE.

[ISSN] 0018-9464

[DOI] 10.1109/TMAG.2007.893636

[NCID] AA00667933

[DOI] http://dx.doi.org/10.1109/TMAG.2007.893636