このエントリーをはてなブックマークに追加
ID 27704
file
creator
Tada, Yosuke
Kunai, Atsutaka
Kunugi, Yoshihito
subject
Polythiophene; Hole-injection; OLED; Annealing
NDC
Metal and mining engineering
abstract
Hole-injection properties of annealed poly(alkoxy- and alkylthiophene) films in OLEDs were studied. Among them, annealed poly(3,3'-dihexyloxy-2,2'-bithiophene) (aPHOBT) film exhibited good hole-injection properties and a triple-layered OLED with the structure ITO/aPHOBT/PVK/Alq3/Mg-Ag (device I) showed much higher performance than a double-layered device without the aPHOBT layer (device II, ITO/PVK/Alq3/Mg-Ag). Device I was slightly inferior to a device having a PEDOT-PSS layeras the hole injector (device III, ITO/PEDOT- PSS/PVK/Alq3/Mg-Ag) in the low-intermediate region of the applied voltage (6-11 V), but gave comparable luminance to III when the applied voltage exceeded 11 V.
journal title
Synthetic Metals
volume
Volume 159
issue
Issue 3-4
start page
214
end page
217
date of issued
2009
publisher
Elsevier Science SA
issn
0379-6779
ncid
publisher doi
language
eng
nii type
Journal Article
HU type
Journal Articles
DCMI type
text
format
application/pdf
text version
author
rights
Copyright (c) 2008 Elsevier B.V.
relation url
department
Graduate School of Engineering